Verified locally
Permits and roofing rules in Upland
A quote is only as good as the rules it was priced against. This is the Upland-specific part: who has jurisdiction, what a re-roof permit involves here, and which requirements have been confirmed against the city’s own documents rather than assumed.
Be first in line
No company gets your details until you say yes to it by name.
You are on the list.
No provider in Upland is taking requests through this service yet. We are lining them up, and yours is kept until one can.
- Nobody gets your details yet. Your request stays with us and is not passed to any company.
- One email when someone can help. When a provider covering your area can take it on, we email you once and ask whether you want that company, by name, to contact you.
- Deleted after 90 days. If nobody can take it on, or you do not say yes, your contact details are deleted 90 days after your request.
- You decide, or you do not. There is nothing to cancel and nothing to pay us.
Nobody will call you about this request unless you say yes to a company by name.
Where we could not confirm something, it is left out rather than guessed at. A short section here means the city publishes little, not that little applies.
The climate zone your roof is built to
Upland is in IECC climate zone 3 and a dry one (the Building America map calls it Hot-Dry), on the Department of Energy county map. That single number is what the energy code is written against here, and it is the reason the same roof is specified differently two states away.
Zone 3 is warm enough that no ice-barrier is required at the eaves, so a quote carrying one is selling you something the code here does not ask for. That is not automatically wrong, but it should be a line you agreed to rather than one you discover.
Attic ventilation is the figure worth checking either way: the energy code works to 1 square foot of net free vent area per 150 square feet of attic floor, or 1 per 300 where the venting is balanced between intake low and exhaust high. Most roofs that fail early in any zone fail because the intake was blocked, not because the covering was cheap.
The statewide layer
These are not specific to Upland, but they apply to it, and several of them are widely got wrong — including by contractors quoting from habit rather than from the current code.
What a wildfire-zone roof actually has to include
Inside a mapped fire hazard zone the requirements go well beyond what the roof is covered with, and the extra details are exactly where a cheap job differs from a compliant one. It is embers rather than a flame front that destroy most houses in a wildfire, and every requirement below closes a gap an ember could use.
- A roof assembly meeting Class A when tested to ASTM E108 or UL 790
- On profiled tile, bird stops at the eaves and hip and ridge caps mudded in, so there is no open end for embers to enter
- Valley flashing of at least 0.019 inch (26 gauge) corrosion-resistant metal, over a mineral-surfaced cap sheet at least 36 inches wide
- Noncombustible gutters and downspouts, with an approved means of stopping leaves and debris collecting in them
- Vent screening of noncombustible corrosion-resistant mesh, no finer than 1/16 inch and no coarser than 1/8 inch
The right to cancel
The standard cancellation window on a home improvement contract is three business days, five for a senior citizen. Where the contract is to repair or restore damage from a disaster or a declared state of emergency, it is seven business days.
It exists precisely because of what happens in a neighbourhood after a storm. Nothing has to be signed on a doorstep, and if something was, the clock above is the reason to read it again tonight rather than tomorrow.
Fire classification: what is actually required, and where
Every ordinary re-roof has to meet at least a Class C fire-retardant covering. That floor applies to new roofs, to repairs and replacements, and to any existing building where over half the roof area is replaced inside a year.
The highest classification, Class A, is pulled in by fire hazard severity zoning or wildland-urban interface designation, and by local ordinances that reach further. Over most of south Orange County the answer ends up being Class A — but it gets there through the zoning and the city, not through a blanket state rule, so it is a question to settle for your address.
One citation to watch for: since 1 January 2026 the wildfire provisions are their own volume, the California Wildland-Urban Interface Code at Title 24 Part 7. It absorbed what used to be building code Chapter 7A and residential code section R337. Anyone still quoting Chapter 7A is quoting a superseded document.
Licensing, deposits and what has to be on the paperwork
Roofing sits under the C-39 classification at the Contractors State License Board. The small-job exemption that permits unlicensed work rose to $1,000 in January 2025, but it does not extend to work needing a permit, and a re-roof needs one. So the rule that matters is the simple one: a re-roof requires a licensed contractor, at any price.
The deposit is capped by statute. A home improvement contractor may not take a down payment of more than $1,000 or ten per cent of the contract, whichever is less, unless they have a blanket performance and payment bond on file with the board. Exceeding it is a misdemeanour, and in a declared disaster area the court is required to impose the maximum fine — which tells you how commonly it is attempted after a storm.
Licence numbers are required in all advertising and on contracts, subcontracts and bids. An advert without one is itself information. The board’s register settles it in under a minute and the minute is worth spending.
How many layers can stay on
A new covering cannot go over the old one where two applications are already up there, where what is there is water-soaked or degraded past being a sound base, or where the existing covering is slate, clay, cement or asbestos-cement tile. Any of those means a strip to the deck.
So two layers is the practical ceiling — and on an older house nobody knows the real number until somebody lifts a corner. It is the commonest reason a re-roof price moves after work starts, which makes it a fair thing to ask a quote to address in advance.
What is typical here — and how we know
What follows is derived rather than verified — reasoning from when the city was built and where it sits, not read off a code document.
We have not compiled a verified housing-era note for Upland, so nothing is claimed here about the typical age or material of its roofs.
The waste side of a re-roof is worth asking about explicitly. How many layers are coming off, where the skip goes, whether the street needs a permit for it, and whether the disposal is inside the quoted price or added afterwards — these are the questions that make two similar-looking quotes turn out not to be similar.
Before you rely on any of this
Rules change, fee schedules are revised annually, and your particular roof may raise something none of this covers. Confirm anything that matters with your city’s building department before work starts — and a contractor who works here every week will already know most of it.
Where each of this came from
These are the pages the facts above came off. They are the authority; this page is a summary of them and can go out of date while they do not.
- California Building Standards Commission — 2025 Title 24, effective 1 January 2026
- California Energy Commission — 2025 Building Energy Efficiency Standards
- CAL FIRE / Office of the State Fire Marshal — Fire Hazard Severity Zone viewer
- CSLB — C-39 roofing classification
- Business & Professions Code 7159.5 — down payment limit
- Business & Professions Code 7030.5 — licence number in advertising
- Insurance Code 2051.5 — time to collect replacement cost
- 10 CCR 2695.7 — Fair Claims Settlement Practices Regulations
- CalRecycle — CALGreen construction and demolition diversion
Commonly asked
Who pulls the permit, me or the contractor?
A licensed contractor pulls it as a matter of course. If one asks you to pull it as an owner-builder, ask why — sometimes there is a reasonable answer, and sometimes it means they cannot.
What is the inspection for?
To confirm that what went on the roof matches what the code requires, at the stage when it can still be seen. A contractor who treats the inspection as an obstacle is telling you something.
Does a re-roof need a permit?
Effectively always for a replacement. Some cities exempt very small repairs by area. The point that matters to a homeowner is not the paperwork but the inspection attached to it, which is a free second opinion on work you cannot see once it is finished.
Ready for a real number?
No cost. We email you once when a provider near you can take it on.